Tag Archives: lubrication for steady rest

  • Top Five Maintenance Tips to Maximize Steady Rest Performance

    Screen Shot 2016-12-20 at 8.29.00 AMSteady rests manufactured by SMW Autoblok are among the best workholders you can buy. But even the finest piece of machinery will lose productivity if not maintained correctly. And while our service professionals would love to pay you a visit, here are some suggestions on how to avoid unnecessary service calls and bolster your bottom line by keeping unexpected downtime to a minimum.

    Tip # 1: Lubricate

    Lube! Lube! Lube! The most important thing you can do to keep your steady rest working smoothly is to keep it well lubricated. We can’t stress this enough. Proper lubrication protects the rollers – the heart and soul of the system – from wearing out prematurely or even burning out during a run. The definition of “proper” will vary depending on the environment you are working in. If you make short runs and keep your shop as clean as an operating room, you can probably get away with lubing once a day. But, if your steady rest is working continuously with exposure to coolant, chips or other contaminants, you might have to stop and apply the proper lubrication every 20 minutes. In more extreme environments, you might have to lube as often as every 5 minutes!

    Tip # 2: Automate the Lubrication Process

    Human nature being what it is, constantly stopping a run every five minutes or so to manually service each grease nipple with a standard grease gun rarely happens. Even if it does, the lost time adds up quickly and productivity drops. That’s why SMW Autoblok recommends that you include an automatic centralized lubrication system when you purchase a steady rest. The automatic system consists of an oiler with a timer that sends pressured lube through ports to rollers and the upper, middle and lower arms. The system is factory set to 60 lube cycles per hour. All the operator has to do is ensure that the oil reservoir is full. Adding air pressure to the system provides the added benefit of continuously purging contamination such as dirt and swarf from the vital areas.

    Tip # 3: Don’t Over Clamp

    Follow the guidelines in the manual for minimum and maximum pressure to apply when clamping a workpiece into the steady rest. Too much pressure will cause rollers to heat up, wear prematurely and lose center position. It can also damage piston seals, causing leaks inside the piston and a loss of pressure. Under-clamping can create slippage between the rollers and the workpiece, diminishing accuracy and productivity.

    Tip # 4: Don’t Skip Standard Annual Maintenance

    Every steady rest should be taken apart and inspected at least once a year to check the guideways, rollers and other internal parts for damage and wear. At that time, all seals should be replaced with seals from a SMW Autoblok Steady Rest Supply Kit. Make sure all the lubrication lines are clear and free of debris that could keep the lubrication from reaching the internal parts. Clean all components with SMW Autoblok Solvent or a comparable commercial product.

    Tip # 5: Look for Hidden Damage

    If the operating machine or the steady rest is subjected to any type of accidental impact, it should be broken down and inspected immediately for any hidden damage to internal parts. Any arms or lines that have been cut or distorted should be replaced for safety and proper mechanical operation.

    Smooth Rolling

    By following these five tips, you can help your SMW Autoblok Steady Rest give you years of valuable service. They will also save you time and money by minimizing unscheduled service calls and maximize profit by allowing the workholder to operate at peak efficiency on a daily basis.

1 Item(s)