FRS

Pull Down Chucks

  • High Precision Pull Down Chucks
  • Size Range: 215mm - 365mm
  • Number of Jaws: 3 Jaws
  • Self Centering
  • Rigid Jaws
  • Large Through Hole
FRS Pull Down Chucks are designed for the self centering clamping of flange or shaft type workpieces where the reference point is not a center but the OD of the workpiece. The through hole of the chuck allows it to swallow the workpiece if needed. Due it its high rigidity against torsion, the chuck can be used for milling as well as turning.
FRS

Product Features

  • For OD clamping only
  • Large through hole
  • Pull down High rigidity against torsion
  • Tongue & groove base jaws
  • Permanent grease lubrication proofline®
  • chucks = full sealed, low maintenance

Standard Equipment

  • 3 Jaw Chuck
  • Mounting bolts